Nov. 2018

Technical Data Sheet

Version 4.0

www.polymaker.com

Tensile testing specimen; ASTM D638 (ISO 527, GB/T 1040)

Disclaimer:

The typical values presented in this data sheet are intended for reference and comparison purposes only. They

should not be used for design specifications or quality control purposes. Actual values may vary significantly with printing

conditions. End- use performance of printed parts depends not only on materials, but also on part design, environmental

conditions, printing conditions, etc. Product specifications are subject to change without notice.

Each user is responsible for determining the safety, lawfulness, technical suitability, and disposal/recycling

practices of Polymaker materials for the intended application. Polymaker makes no warranty of any kind, unless

announced separately, to the fitness for any use or application. Polymaker shall not be made liable for any damage, injury

or loss induced from the use of Polymaker materials in any application.

80.00

115.00

33.00

R14.00

R25.00

Z axis