Tyco Electronics Corporation

300 Constitution Drive

Faraday Road

3816 Noborito, Tama-ku

Asia Pacific Headquarters

Menlo Park, CA 94025-1164

Dorcan, Swindon, SN3 5HH

Kawasaki, Kanagawa 214-8533

26 Ang Mo Kio, Industrial Park 2

USA

United Kingdom

Japan

Singapore 569507

Tel: (800) 926-2425 (US & Canada)

Tel: +44 1793 528171

Tel: +81 44 900 5102

Tel: +65 4866 151

Tel: +1 (650) 361-3860 (All other countries)

Users should independently evaluate the suitability of the product for their application.

For more information about this product visit www.tycoelectronics.com

All information, including illustrations, is believed to be reliable. Users, however, should independently evaluate the suitability of each product for their application. Tyco Electronics Corporation makes

no warranties as to the accuracy or completeness of the information, and disclaims any liability regarding its use. Tyco Electronics Corporation’s only obligations are those in the Standard Terms and

Conditions of Sale for these products and in no case will Tyco Electronics Corporation be liable for any incidental, indirect, or consequential damages arising from the sale, resale, use, or misuse of the

product. Tyco Electronics Corporation’s Specifications are subject to change without notice. In addition, Tyco Electronics Corporation reserves the right to make changes in materials or processing

without notification to the Buyer which do not affect compliance with any applicable specification.

Specification values

Property

Unit

Requirement

Method of test

Physical

Dimensions

mm (inches)

See reverse

ASTM D 2671

Longitudinal change

percent

+0, –10 maximum

ASTM D 2671

Flow of inner wall

No openings upon reheating

AMS-DTL-23053/4

Tensile strength

psi (MPa)

1500 (10.3) minimum

ASTM D 2671

Ultimate elongation

percent

200 minimum

ASTM D 2671

Low-temperature brittleness

No failure

ASTM D 746

at –55°C/–67°F

Procedure B

Heat shock

No dripping, flowing, or

AMS-DTL-23053

(4 hours at 250°C/482°F)

cracking of the outer wall

Heat resistance

No dripping, flowing, or

AMS-DTL-23053

(168 hours at 175°C/347°F)

cracking of the outer wall

Electrical

Dielectric strength

volts/mil

500 minimum

ASTM D 2671

Volume resistivity

ohm-cm

1015 minimum

ASTM D 257

Chemical

Corrosive effect

Noncorrosive

ASTM D 2671

(16 hours at 121°C/250°F)

Procedure A

Fungus resistance

Rating of 1 or less

ASTM G 21

Water absorption

percent

0.1 maximum

ASTM D 570

(24 hours at 23°C/73°F)

Fluid resistance

ASTM D 2671

(24 hours at 23°C/73°F) in:

JP-8 Fuel (MIL-T-5624)

Skydrol* 500

Hydraulic fluid (MIL-H-5606)

Aviation gasoline 100/130

Water

Followed by tests for:

Dielectric strength

volts/mil

400 minimum

ASTM D 2671

Tensile strength

psi

1000 minimum

ASTM D 2671

Note: These requirements apply to PD Cap material only. These tests, except dimensions and longitudinal change, cannot be performed on material in PD Cap configuration.

*Trademark of the Monsanto Company.

Raychem is a trademark of Tyco Electronics Corporation.