| Datenblatt-Suchmaschine für elektronische Bauteile |
|
AAT3103 Datenblatt(PDF) 8 Page - Advanced Analog Technology, Inc. |
|
|
|||||||||||||||||||||||||||||
AAT3103 Datenblatt(HTML) 8 Page - Advanced Analog Technology, Inc. |
|
8 / 17 page ![]() AAT3103 3-Channel Charge-Pump LED Driver ChargePumpTM PRODUCT DATASHEET 8 3103.2008.03.1.0 www .analogictech.com AAT3103 3-Channel Charge-Pump LED Driver ChargePumpTM PRODUCT DATASHEET 8 3103.2008.03.1.0 www .analogictech.com Functional Description The AAT3103 is a low-cost charge-pump solution designed to drive up to three WLEDs. The charge pump operates from a 2.7V to 5.5V power source and converts it to volt- age levels necessary to drive the LEDs. LED current is individually controlled through integrated current sourc- es powered from the output of the charge pump. Low 1x charge-pump output resistance and low-drop voltage current sources allow the charge pump to stay in 1x mode with an input voltage as low as 3.75V and LED forward voltages as high as 3.2V with 20mA LED current. Once in 2x mode, the charge pump monitors the input supply voltage and automatically switches back to 1x mode when there is sufficient input voltage. The AAT3103 requires only four external components: one 1μF ceramic capacitor for the charge pump flying capacitors (CP), one 1μF ceramic input capacitor (CIN), one 1μF ceramic output capacitor (COUT) and a resistor (RSET) to set the maximum LED current. The three con- stant current outputs of the AAT3103 (D1 to D3) can drive three individual LEDs with a maximum current of 30mA each. AnalogicTech’s S2Cwire serial interface enables the AAT3103-1/-2 and changes the current source magnitudes through the EN/SET pin. The AAT3103-4 uses an external PWM signal to enable the IC and control the brightness of the LEDs. Constant Current Control Using RSET The maximum current is programmed by an external resistor at the RSET pin. With a 14.3kΩ external resistor at the RSET pin, the AAT3103 includes an integrated serial LED current control that sets the full-scale LED current between 20mA and 0.67mA. The full-scale LED current can be set higher or lower than 20mA; see Table 4. For maximum accuracy, a 1% tolerance resistor is recommended. Functional Block Diagram C– C+ OUT AGND IN D3 D2 D1 S 2Cwire Control (PWM Control) DAC EN/SET (EN/PWM) RSET Two-Mode CP Control VF Monitoring 3 IREF |
|
|
Link URL |
| War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Link zum Datenblatt | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |