L6711 datasheet(32/50 Pages) STMICROELECTRONICS

Teilenummer	L6711

Bauteilbeschribung	3 Phase controller with dynamic VID and selectable DACs

PDF	50 Pages

Scroll/Zoom	100%

Hersteller	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

32 / 50 page

Soft start

L6711

32/50

Soft start

During soft start, a ramp is generated increasing the loop reference from 0V to the final

value programmed by VID in 2048 clock periods as shown in

Figure 15. Once the soft start begins, the reference is increased: upper and lower MOS

begin to switch and the output voltage starts to increase with closed loop regulation. At the

end of the digital soft start, the SS_END signal is then driven high.

The Under Voltage comparator is enabled when the reference voltage reaches 0.6V while

Over Voltage Comparator is always enabled during soft start with a threshold equal to the

115% of the programmed reference or the threshold programmed by ROVP (see relevant

section).

Figure 15.

Soft start

VCC=VCCDR

VLGATEx

SS_END

VOUT

Turn ON threshold

2048 Clock Cycles

(CH1=VOUT; CH2=LGATEx; CH3=SS_END)

L6711 Datenblatt(PDF) 32 Page - STMicroelectronics