8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ASSEMBLY

1. Insert the chain holder

assembly into the base as

shown and secure from

below using the Locking

Wheel supplied.

• Make sure the pointer is

positioned pointing

forwards (away from the

grinding wheel).

2. Bolt (bolts not included) the

unit directly to the

workbench through the two

1/4” holes in the base. Making sure the Locking Wheel is overhanging the edge of

the workbench, with enough room to turn it.

• The workbench must have a solid surface capable of supporting the weight of

the sharpener and the work piece.

OPERATION

NOTE: Sharpen all the teeth on one side first (every other tooth) before

adjusting the angle to complete the job.

NOTE: ALWAYS raise the Top Housing while adjusting the chain.

1. Put on protective goggles and make sure the immediate area is clear of

bystanders.

2. Clean the chain before sharpening it. Wash it with a non-flammable solvent. DO

NOT use petrol or diesel. Dry the chain.

WARNING: MAKE SURE THE SHARPENER IS NOT CONNECTED TO

THE MAINS POWER SUPPLY DURING SETUP.

WARNING: NEVER OPERATE THE TOOL WITHOUT THE GRINDING

WHEEL COVER IN PLACE.

WARNING: WHEN SHARPENING, ALWAYS WEAR SAFETY GOGGLES.

WARNING: ALWAYS SWITCH OFF THE TOOL WHEN ADJUSTING THE

CHAIN FOR SHARPENING.