7

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

PREPARATION

CHANGING THE SANDING BELT

1. Pull out the belt tension lever.

2. Slide the old belt away from the rollers.

3. Slide the new sanding belt into position over the front and rear rollers, ensuring

that the arrows on the sanding belt and on the tool are pointing in the same

direction.

4. Push the sanding belt tension lever back into the recess to apply the tension.

CAUTION: DISCONNECT THE PLUG FROM THE POWER SUPPLY BEFORE

CHANGING THE BELT.