9

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

9. The MIG welding process uses an INERT gas to protect the weld pool. It is

important to ensure the appropriate gas is being used. NEVER use gas from

a cylinder, the content of which is unknown.

NEVER

a. Use a damaged cylinder.

b. Lift the cylinder by the valve.

c. Expose the cylinder to a heat source or sparks.

10. NEVER use or store in a damp environment. DO NOT EXPOSE TO RAIN.

11. ALWAYS keep a fire extinguisher handy. (Dry Powder, C02 or BCF, NOT

Water)

12. NEVER attempt any electrical or mechanical repair unless your are a

qualified technician. If you have a problem with the machine contact your

local CLARKE dealer.

13. NEVER continue to weld, if, at any time, you feel even the smallest electric

shock. Stop welding IMMEDIATELY and DO NOT attempt to use the

machine until the fault is diagnosed and corrected.

14. NEVER point the MIG torch at any person or animal.

15. NEVER touch the MIG torch nozzle until the welder is switched OFF and the

nozzle has been allowed to cool.

16. NEVER connect, disconnect, or attempt to service the welding torch, until

the machine is switched OFF and disconnected from the power supply.

17. NEVER allow the earth cable or torch hose to become wrapped around

the operator or any person in the vicinity.

A comprehensive range of CLARKE safety equipment for use when welding is

available from your local dealer.

Consideration should be given to shielding the supply cable of permanently

installed welding equipment, in metallic conduit or equivalent. Shielding

should be electrically continuous throughout its length.

The shielding should be connected to the welding power source so that good

electrical contact is maintained between the conduit and the welding power

source enclosure.

The welding equipment should be maintained according to the

manufacturer’s recommendations. All access and service doors and covers

should be closed and properly fastened when the equipment is in operation.

The welding equipment should not be modified in any way except for those

changes and adjustments covered in the manufacturer’s instructions. In

particular, the spark gaps of arc striking and stabilizing devices should be

adjusted and maintained according to the manufacturers recommendations.