Assembly instructions

NOTE

Before installing, please remove the protective white paper from the thermal silicone.

1. Install Compute Module 5 onto the Compute Module 5 IO Board (or other carrier

board), if using.

2. Place four M2.5 × H1.5 or M2.5 × H3 nylon washers (supplied) between Compute

Module 5 and the IO Board, around the four mounting holes.

3. As shown in the diagram below, place the Cooler onto Compute Module 5,

align the mounting holes, insert four M2.5 × 8 screws (supplied) upwards from

beneath the IO Board, and tighten.

!

Raspberry Pi Cooler for Raspberry Pi Compute Module 5 – Raspberry Pi Ltd

4