NRF24L01P-R datasheet(34/78 Pages) NORDIC

34 / 78 page

Revision 1.0

Page 34 of 78

nRF24L01+ Product Specification

•

Auto Retransmit Delay (ARD) has elapsed.

•

No address match within 250µs (or 500µs in 250kbps mode).

•

After received packet (CRC correct or not).

nRF24L01+ asserts the TX_DS IRQ when the ACK packet is received.

nRF24L01+ enters standby-I mode if there is no more untransmitted data in the TX FIFO and the CE pin is

low. If the ACK packet is not received, nRF24L01+ goes back to TX mode after a delay defined by ARD

and retransmits the data. This continues until acknowledgment is received, or the maximum number of

retransmits is reached.

Two packet loss counters are incremented each time a packet is lost, ARC_CNT and PLOS_CNT in the

OBSERVE_TX

You reset ARC_CNT by initiating a new transaction. The PLOS_CNT counts the total number of retrans-

missions since the last channel change. You reset PLOS_CNT by writing to the RF_CH register. It is possi-

ble to use the information in the OBSERVE_TX register to make an overall assessment of the channel

quality.

The ARD defines the time from the end of a transmitted packet to when a retransmit starts on the PTX.

ARD is set in SETUP_RETR register in steps of 250µs. A retransmit is made if no ACK packet is received by

the PTX.

There is a restriction on the length of ARD when using ACK packets with payload. The ARD time must

never be shorter than the sum of the startup time and the time on-air for the ACK packet:

•

For 2Mbps data rate and 5 byte address; 15 byte is maximum ACK packet payload length for

ARD=250µs (reset value).

•

For 1Mbps data rate and 5 byte address; 5 byte is maximum ACK packet payload length for

ARD=250µs (reset value).

ARD=500µs is long enough for any ACK payload length in 1 or 2Mbps mode.

•

For 250kbps data rate and 5byte address the following values apply:

Table 18. Maximum ACK payload length for different retransmit delays at 250kbps

As an alternative to Auto Retransmit it is possible to manually set the nRF24L01+ to retransmit a packet a

number of times. This is done by the REUSE_TX_PL command. The MCU must initiate each transmission

of the packet with a pulse on the CE pin when this command is used.

ARD

ACK packet size (in bytes)

1500µs

All ACK payload sizes

1250µs

< 24

1000µs

< 16

750µs

< 8

500µs

Empty ACK with no payload

NRF24L01P-R Datenblatt(PDF) 34 Page - Nordic Semiconductor

NRF24L01P-R Datenblatt(HTML) 34 Page - Nordic Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78

Datenblatt Download

Link URL