TLC080 datasheet(25/47 Pages) TI

25 / 47 page

TLC080, TLC081, TLC082, TLC083, TLC084, TLC085, TLC08xA

FAMILY OF WIDEBANDWIDTH HIGHOUTPUT DRIVE SINGLE SUPPLY

OPERATIONAL AMPLIFIERS

SLOS254E − JUNE 1999 − REVISED APRIL 2006

WWW.TI.COM

APPLICATION INFORMATION

macromodel information

Macromodel information provided was derived using Microsim Parts

, the model generation software used

with Microsim PSpice

. The Boyle macromodel (see Note 1) and subcircuit in Figure 54 are generated using

the TLC08x typical electrical and operating characteristics at TA = 25°C. Using this information, output

simulations of the following key parameters can be generated to a tolerance of 20% (in most cases):

D Maximum positive output voltage swing

D Maximum negative output voltage swing

D Slew rate

D Quiescent power dissipation

D Input bias current

D Open-loop voltage amplification

D Unity-gain frequency

D Common-mode rejection ratio

D Phase margin

D DC output resistance

D AC output resistance

D Short-circuit output current limit

NOTE 2: G. R. Boyle, B. M. Cohn, D. O. Pederson, and J. E. Solomon, “Macromodeling of Integrated Circuit Operational Amplifiers,” IEEE Journal

of Solid-State Circuits, SC-9, 353 (1974).

PSpice and Parts are trademarks of MicroSim Corporation.

TLC080 Datenblatt(PDF) 25 Page - Texas Instruments