ST7263BEX datasheet(91/186 Pages) STMICROELECTRONICS

91 / 186 page

ST7263Bxx

On-chip peripherals

Doc ID 7516 Rev 8

91/186

3 OR Overrun error.

This bit is set by hardware when the word currently being received in the shift

is generated if RIE=1 in the SCICR2 register. It is cleared by a software sequence

(an access to the SCISR register followed by a read to the SCIDR register).

0: No Overrun error

1: Overrun error is detected

Note: When this bit is set RDR register content will not be lost but the shift register

will be overwritten.

2NF Noise flag.

This bit is set by hardware when noise is detected on a received frame. It is cleared

by a software sequence (an access to the SCISR register followed by a read to the

SCIDR register).

0: No noise is detected

1: Noise is detected

Note: This bit does not generate interrupt as it appears at the same time as the

RDRF bit which itself generates an interrupt.

1 FE Framing error.

This bit is set by hardware when a de-synchronization, excessive noise or a break

character is detected. It is cleared by a software sequence (an access to the SCISR

0: No Framing error is detected

1: Framing error or break character is detected

Note: This bit does not generate interrupt as it appears at the same time as the

RDRF bit which itself generates an interrupt. If the word currently being

transferred causes both frame error and overrun error, it will be transferred

and only the OR bit will be set.

0 PE Parity error.

This bit is set by hardware when a parity error occurs in receiver mode. It is cleared

by a software sequence (a read to the status register followed by an access to the

SCIDR data register). An interrupt is generated if PIE=1 in the SCICR1 register.

0: No parity error

1: Parity error

ST7263BEx Datenblatt(PDF) 91 Page - STMicroelectronics