ATmega32U2 datasheet(53/314 Pages) ATMEL

53 / 314 page

7799B–AVR–07/09

ATmega8U2/16U2/32U2

While the WDT prescaler allows only even division factors (2, 4, 8...), the WDT peripheral also

includes a clock divider that directly acts on the clock source. This divider handles odd division

factors (3, 5, 7). In combination with the prescaler, a large number of time-out values can be

obtained.

The divider factor change is also ruled by the secure timed sequence : first the WDE and WDCE

bits must be set, and then four cycles are available to load the new divider value into the

WDTCKD register. Be aware that after this operation WDE will still be set. So keep in mind the

importance of order of operations. When setting up the WDT in Interrupt mode with specific val-

ues of prescaler and divider, the divider register must be loaded before the prescaler register :

Set WDCE and WDE

Load the divider factor into WDTCKD

Wait WDCE being automatically cleared (just wait 2 more cycles)

Set again WDCE and WDE

Clear WDE, set WDIE and load the prescaler factor into WDTCSR in a same operation

Now the system is properly configured for Interrupt only mode. Inverting the two opera-

tions would have been resulted into “Reset and Interrupt mode” and needed a third

operation to clear WDE.

The following code example shows one assembly and one C function for turning off the Watch-

dog Timer. The example assumes that interrupts are controlled (e.g. by disabling interrupts

globally) so that no interrupts will occur during the execution of these functions.

ATmega32U2 Datenblatt(PDF) 53 Page - ATMEL Corporation