PD080SL3

The information contained herein is the exclusive property of Prime View International Co., Ltd. and shall not be distributed,

reproduced, or disclosed in whole or in part without prior written permission of Prime View International Co., Ltd.Page:23

13. Handling Cautions

13-1) Mounting of module

a)

Please power off the module when you connect the input/output connector.

b) Polarizer which is made of soft material and susceptible to flaw must be handled carefully.

c) Protective film (Laminator) is applied on surface to protect it against scratches and diets.

d)

Please following the tear off direction as figure13-1 to remove the protective film as slowly as

possible, so that electrostatic charge can be minimized.

13-2) Precautions in mounting

a) When metal part of the TFT-LCD module (shielding lid and rear case) is soiled, wipe it with soft dry

cloth.

b) Wipe off water drops or finger grease immediately. Long contact with water may cause discoloration

or spots.

c) TFT-LCD module uses glass, which breaks or cracks easily if dropped or bumped on hard surface.

Please handle with care.

d) Since CMOS LSI is used in the module. So take care of static electricity and earth yourself when

handling.

13-3) Adjusting module

a) Adjusting volumes on the rear face of the module have been set optimally before shipment.

b) Therefore, do not change any adjusted values. If adjusted values are changed, the specifications

described may not be satisfied.

13-4) Others

a) Do not expose the module to direct sunlight or intensive ultraviolet rays for many hours.

b) Store the module at a room temperature place.

c) The voltage of beginning electric discharge may over the normal voltage because of leakage current

from approach conductor by to draw lump read lead line around.

d) If LCD panel breaks, it is possibly that the liquid crystal escapes from the panel.

Avoid putting it into eyes or mouth. When liquid crystal sticks on hands, clothes or feet. Wash it out

immediately with soap.

e) Observe all other precautionary requirements in handling general electronic components.

f) Please adjust the voltage of common electrode as material of attachment by 1 module.

Figure 13 -1 the way to peel off protective film

P-511-475(V:3)