XIO2001 datasheet(27/128 Pages) TI

27 / 128 page

PCIR

XIO2001

www.ti.com

SCPS212D – MAY 2009 – REVISED JANUARY 2010

Table 3-3. Messages Supported by the Bridge (continued)

MESSAGE

SUPPORTED

BRIDGE ACTION

ERR_FATAL

Yes

Transmitted upstream

Set_Slot_Power_Limit

Yes

Received and processed

Unlock

Discarded

Hot plug messages

Discarded

Advanced switching messages

Discarded

Vendor defined type 0

Unsupported request

Vendor defined type 1

Discarded

All supported message transactions are processed per the PCI Express Base Specification.

3.4

PCI Bus Interface

3.4.1

I/O Characteristics

Figure 3-4 shows a 3-state bi-directional buffer that represents the I/O cell design for the PCI bus.

Section 7.7, Electrical Characteristics over Recommended Operating Conditions, provides the electrical

characteristics of the PCI bus I/O cell.

NOTE

The PCI bus interface on the bridge meets the ac specifications of the PCI Local Bus

Specification. Additionally, PCI bus terminals (input or I/O) must be held high or low to

prevent them from floating.

Figure 3-4. 3-State Bidirectional Buffer

3.4.2

Clamping Voltage

In the bridge, the PCI bus I/O drivers are powered from the VDD_33 power rail. Plus, the I/O driver cell is

tolerant to input signals with 5-V peak-to-peak amplitudes.

For PCI bus interfaces operating at 50MHz or 66 MHz, all devices are required to output only 3.3-V

peak-to-peak signal amplitudes. For PCI bus interfaces operating at 25-MHz or 33-MHz, devices may

output either 3.3-V or 5-V peak-to-peak signal amplitudes. The bridge accommodates both signal

amplitudes.

Each PCI bus I/O driver cell has a clamping diode connected to the internal VCCP voltage rail that protects

the cell from excessive input voltage. The internal VCCP rail is connected to two PCIR terminals. If the PCI

signaling is 3.3-V, then PCIR terminals are connected to a 3.3-V power supply via a 1k

Ω resistor. If the

PCI signaling is 5-V, then the PCIR terminals are connected to a 5-V power supply via a 1k

Ω resistor.

The PCI bus signals attached to the VCCP clamping voltage are identified as follows

•

Table 2-5, PCI System Terminals, all terminal names except for PME

•

Table 2-7, Miscellaneous Terminals, the terminal name SERIRQ.

Feature/Protocol Descriptions

Submit Documentation Feedback

Product Folder Link(s): XIO2001

XIO2001 Datenblatt(PDF) 27 Page - Texas Instruments

XIO2001 Datenblatt(HTML) 27 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datenblatt Download

Link URL