L6228Q datasheet(16/32 Pages) STMICROELECTRONICS

16 / 32 page

Circuit description

L6228Q

16/32

Doc ID 14321 Rev 4

Figure 15.

Area where tON can vary maintaining the PWM regulation

4.4

Decay modes

The CONTROL input is used to select the behavior of the bridge during the off time. When

the CONTROL pin is low, the fast decay mode is selected and both transistors in the bridge

are switched off during the off time. When the CONTROL pin is high, the slow decay mode

is selected and only the low side transistor of the bridge is switched off during the off time.

Figure 16 shows the operation of the bridge in the fast decay mode. At the start of the off

time, both of the power MOS are switched off and the current recirculates through the two

opposite free wheeling diodes. The current decays with a high dI/dt since the voltage across

the coil is essentially the power supply voltage. After the dead time, the lower power MOS in

parallel with the conducting diode is turned on in synchronous rectification mode. In

applications where the motor current is low it is possible that the current can decay

completely to zero during the off time. At this point if both of the power MOS were operating

in the synchronous rectification mode it would then be possible for the current to build in the

opposite direction. To prevent this only the lower power MOS is operated in synchronous

rectification mode. This operation is called quasi-synchronous rectification mode. When the

monostable times out, the power MOS are turned on again after some delay set by the dead

time to prevent cross conduction.

Figure 17 shows the operation of the bridge in the slow decay mode. At the start of the off

time, the lower power MOS is switched off and the current recirculates around the upper half

of the bridge. Since the voltage across the coil is low, the current decays slowly. After the

dead time the upper power MOS is operated in the synchronous rectification mode. When

the monostable times out, the lower power MOS is turned on again after some delay set by

the dead time to prevent cross conduction.

0.1

100

Coff [nF]

2.5μs (typ. value)

L6228Q Datenblatt(PDF) 16 Page - STMicroelectronics