SC1158

PROGRAMMABLE SYNCHRONOUS DC/DC

CONTROLLER FOR ADVANCED PROCESSORS

© 2000 SEMTECH CORP.

652 MITCHELL ROAD NEWBURY PARK CA 91320

Preliminary - August 7, 2000

4

THEORY OF OPERATION

The voltage at the VOSENSE pin is applied, through the internal precision resistor feedback chain, to the inverting

input of the error amplifier. The non-inverting input of the error amplifier is supplied with a DC voltage derived by

the DAC from the internal trimmed bandgap voltage reference. The output of the error amplifier is compared to the

triangular output of the internal oscillator to generate a fixed frequency, variable duty cycle pulse train. The internal

oscillator uses an on-chip capacitor and precision trimmed current sources to set the frequency to 140 kHz.

The generated pulse train is gated with the output of the current limit latch and the inhibit signal to produce a drive

signal for the upper FET. It is also inverted to produce a drive signal for the lower FET. These FET drive signals

are modified by the “shoot-through control” circuitry so that the top FET turn-on is delayed until the bottom FET has

turned off, and visa-versa.

The current limit latch is set (ending the upper FET drive pulse early) if the current limit comparator indicates an

overcurrent condition. The latch is reset at the start of each oscillator period.

OUTPUT VOLTAGE TABLE

Unless specified: V

T

PARAMETER

CONDITIONS

VID

3210

MIN

TYP

MAX

UNITS

Output Voltage

(1)

I

1111

1.980

2.000

2.020

V

(Figure 1)

1110

2.079

2.100

2.121

1101

2.178

2.200

2.222

1100

2.277

2.300

2.323

1011

2.376

2.400

2.424

1010

2.475

2.500

2.525

1001

2.574

2.600

2.626

1000

2.673

2.700

2.727

0111

2.772

2.800

2.828

0110

2.871

2.900

2.929

0101

2.970

3.000

3.030

0100

3.069

3.100

3.131

0011

3.168

3.200

3.232

0010

3.267

3.300

3.333

0001

3.366

3.400

3.434

0000

3.465

3.500

3.535