TDA7512F datasheet(19/45 Pages) STMICROELECTRONICS

19 / 45 page

TDA7512F

Functional description

Doc ID 12668 Rev 2

19/45

softmute. This value is compared with comparator5 thresholds (ACM). For present strong

adjacent channel the MPX signal is additional attenuated (ACMD).

4.5

PLL and IF counter section

4.5.1

PLL frequency synthesizer block

This part contains a frequency synthesizer and a loop filter for the radio tuning system. Only

one VCO is required to build a complete PLL system for FM world tuning . For auto search

stop operation an IF counter system is available.

The counter works in a two stages configuration. The first stage is a swallow counter with a

two modulus (32/33) precounter. The second stage is an 11-bit programmable counter.

The circuit receives the scaling factors for the programmable counters and the values of the

reference frequencies via an I2C bus interface.The reference frequency is generated by an

adjustable internal (XTAL) oscillator followed by the reference divider. The main reference

and step-frequencies are free selectable (RC, PC).

Output signals of the phase detector are switching the programmable current sources. The

loop filter integrates their currents to a DC voltage.

The values of the current sources are programmable by 6 bits also received via the I2C Bus

(A, B, CURRH).

To minimize the noise induced by the digital part of the system, a special guard

configuration is implemented. The loop gain can be set for different conditions by setting the

current values of the chargepump generator.

4.5.2

Frequency generation for phase comparison

The RF signals applies a two modulus counter (32/33) pre-scaler, which is controlled by a 5-

bit A-divider. The 5-bit register (PC0 to PC4) controls this divider. In parallel the output of the

prescaler connects to an 11-bit B-divider. The 11-bit PC register (PC5 to PC15) controls this

divider

Dividing range:

fVCO = [33 x A + (B + 1 - A) x 32] x fREF

fVCO = (32 x B + A + 32) x fREF

Important: For correct operation: A ≤ 32; B ≥ A

4.5.3

Three state phase comparator

The phase comparator generates a phase error signal according to phase difference

between fSYN and fREF. This phase error signal drives the charge pump current generator.

4.5.4

Charge pump current generator

This system generators signed pulses of current. The phase error signal decides the

duration and polarity of those pulses. The current absolute values are programmable by A

TDA7512F Datenblatt(PDF) 19 Page - STMicroelectronics

TDA7512F Datenblatt(HTML) 19 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

Datenblatt Download

Link URL