RMT Ltd.

2MP04-096 Series

Copyright 2005. RMT Ltd. The design and specifications of products can be changed by RMT Ltd. without notice.

RMTK 170.00.00

53 Leninskij prosp. Moscow 119991 Russia, phones: 7-095-132-6817, 7-095-132-6685, fax: 7-095-132-5870, e-mail: rmtcom@dol.ru

2MP04-096-15

Standard Perfomance Plots

Application tips

Cautions

2. Never use TE module without attached heat sink at

hot (bottom) side.

Installation

1. Mechanical Mounting

TEC is placed between two heat exchangers . This construction is fixed by screws or in

another mechanical way.

It is suitable for large modules (with dimensions 30mmx30mm and larger). Miniature types

require other assembling methods.

2. Soldering

This method is suitable for a TE module with metallized outside surfaces (cold and hot

sides). RMT provides this option and also makes pre-tinning for TE modules. In comparison

with a mechanical assembling method, soldering requires careful procedures.

3. Glueing

It is an up-to-date method that is used by many customers due to availability of glues with

good thermoconductive properties. A glue is usually based on some epoxy compound filled

with some thermoconductive material such as graphite or diamond powders, silver, SiN and

others. The application of a specific type depends on application features and the type of a

TE module.

3. Connect TE module to DC power supply according to

polarity

4. Do not apply DC current higher than Imax.

0

10

20

30

40

50

60

70

80

90

100

0.0

0.5

1.0

1.5

2.0

2.5

3.0

3.5

Current, A

0

10

20

30

40

50

60

70

80

90

100

0.0

0.5

1.0

1.5

2.0

Q, W

Imax

0.8 Imax

0.6 Imax

0.4 Imax

0

1

2

3

4

5

6

0

10

20

30

40

50

60

70

80

90

100

DT, K

Imax

0.8 Imax

0.6 Imax

0.4 Imax

0.0

0.5

1.0

1.5

0

10

20

30

40

50

60

70

DT, K

433