Condor D.C. Power Supplies, Inc., A subsidiary of SL Industries, Inc. 805-486-4565 • (800) 235-5929 Fax: (805) 487-8911 http://www.condorpower.com

Option “G”, DC Power Good ( 5 V outputs)*: Provides a TTL “1” open collector when output

is above 4.6 V nominal. Not available if option “P” is selected.

Option “P”, AC Power Fail: Provides TTL “0” 5 ms before output voltage goes out of

regulation band upon loss of AC power. VMEbus compatible, provides 48 mA sink

current capability. Not available if option “G” is selected.

Option “V”, Fan/Cover Assembly*: Low profile, end venting cover with integral ball-bearing

fan.

*Options C, F, G, and V not available on 150 and 180 watt models.

Consult factory for other available options.

100, 150, 165, 180, 250 WATTS

350, 360, 500, 520 WATTS

9”x 5”x 2.5”

11.5”x 5”x 2.5”

SC-100,150, 180, 250

SC-350, 360, 500, 520

FUNCTION

115 VAC

230 VAC

CONNECTOR

Input Select

Short

Open

0.110,0.187, or 0.250

male Fastons

TB1-

Line

Line 1

TB1-

Neutral

Line 2

TB1-

Safety Ground

Safety Ground

AC INPUT

Barrier strip

#6-32 screws

3/8” centers

STATUS AND CONTROL

SPECIFICATIONS: ALL MODELS

INPUT

AC Input: 90-132 Vac/180-264 Vac, 47 to 63 Hz. User selectable. See option “A” for automatic

line selection. 150 watt units fused for 7 A. 250 watt units fused for 10 A. 350 and 500

watt units fused for 15 A.

Inrush: Cold start AC current is less than 16 A at 115 Vac and 32 A at 230 Vac for 150 watt

models; 10 A at 115 Vac and 18 A at 230 Vac for 250 watt models; 80 A at 115 Vac and

20 A at 230 Vac for 350 and 500 watt models. Limited by thermistor.

Holdup Time: 16 ms minimum after removal of power, at nominal line, full load.

Efficiency: 80% typical.

Brownout Protection: Holds regulation to 85 Vac or 170 Vac.

OUTPUT

Adjustability: User adjustable ±10% minimum.

Line & Load Reg: ±1% over AC input range and 0 to 100% load change.

Ripple & Noise: Less than 1% p-p or 100 mV, whichever is greater.

Remote Sense: Compensates for 250 mV total line drop. Open sense lead protection.

Temperature Coefficient: 0.02% per degree C.

Stability: 0.1% over 8 hours after 30 minutes warm-up.

Transient Response: Output voltage returns to within 1% in less than 500 µs for a 50% load

change. Peak transient does not exceed 5%.

Overload Protection: All outputs are protected against overload and short circuit. Automatic

recovery upon removal of fault.

Overvoltage Protection: Protects load against power supply induced overvoltage. Trip point is

factory set so that output voltage cannot exceed 136% of nominal.

Remote Inhibit: Contact closure to the negative sense line drops output power to nominal

zero. Not available in 150 or 180 watt units.

Reverse Voltage: Protected against reverse voltage up to supply current rating.

ENVIRONMENTAL

Thermal Protection: Shuts down power supply if overheated. Automatic recovery.

Temperature Range: 0° to 50°C at full ratings. Derate to half power at 70 °C.

Safety Agencies: Most models are approved to UL1950; CSA 22.2 #234; IEC 950 and TÜV

EN60950, Class 1 SELV., CE 72/23/EEC/93/68EEC (low voltage directive).

Conducted RFI: Meets FCC Part 15, Subpart J, Class A; EN55022 Class B; CISPR 22 Class B.

Output Isolation: Isolated from ground 50 Vdc, except 100 Vdc for 48 Vdc models.

Cooling: 30 CFM required to achieve full ratings.

OPTIONS:

Option “A”, AC Auto-Range: Automatically selects proper AC line voltage range to enable

power operation at either 115 or 230 Vac without user intervention.

Option “C”, Cover*: Limits contact with power supply interior.

Option “F”, Fan/Cover Assembly*: Cover with integral ball-bearing fan provides proper

cooling to achieve full ratings at 50°C ambient temperature.

FUNCTION

MODEL

LOCATION

CONNECTOR

All SC-150W models

Terminal +5V

Bus bars

Terminal COM

#6-32 screws

Output

All SC-250W models

Terminal +V

Bus bars

Voltage

Terminal COM

#8-32 screws

All SC-350W and 500W

Terminal +V

Bus bars

models

Terminal COM

#1/4-20 screws

DC OUTPUT

FUNCTION

SC-150W CONNECTOR SC-250W SC-350 & 500W

CONNECTOR

Remote Sense

+S

#6-32 screw J1-1 (+S)

J1-4 (+S)

AMP MTA type

–S

terminals

J1-2 (–S)

J1-3 (–S)

640456-4

AC Power Fail

PF

J1-3 (PF)

J1-2 (PF)

pin header

DC Power Good

(locking)

Inhibit

J1-4 (IH)

J1-1 (INH)

SC-350, 360, 500, 520

3.8 lbs - 1.7 kgs

SC-100, 150, 165, 180, 250

2.0 lbs - 0.9 kgs

Dimensions:

Inches

Millimeters

(L )

(N)

( )