ICS85320AMILF datasheet(7/16 Pages) IDT

7 / 16 page

IDT™ / ICS™ 3.3V, 2.5V LVPECL TRANSLATOR

ICS8532AMI REV A NOVEMBER 13, 2006

ICS85320I

LVCMOS/LVTTL-TO-DIFFERENTIAL 3.3V, 2.5V LVPECL TRANSLATOR

APPLICATION INFORMATION

CC - 2V

Ω

RTT

o = 50Ω

FOUT

FIN

RTT =

((V

OH + VOL) / (VCC – 2)) – 2

3.3V

125

Ω

125

Ω

o = 50Ω

FOUT

FIN

The clock layout topology shown below is a typical termination

for LVPECL outputs. The two different layouts mentioned are

recommended only as guidelines.

FOUT and nFOUT are low impedance follower outputs that gen-

erate ECL/LVPECL compatible outputs. Therefore, terminating

resistors (DC current path to ground) or current sources must be

used for functionality. These outputs are designed to drive 50

Ω

transmission lines. Matched impedance techniques should be

used to maximize operating frequency and minimize signal dis-

tortion.

Figures 1A and 1B show two different layouts which are

recommended only as guidelines. Other suitable clock layouts

may exist and it would be recommended that the board design-

ers simulate to guarantee compatibility across all printed circuit

and clock component process variations.

TERMINATION FOR LVPECL OUTPUTS

FIGURE 1B. LVPECL OUTPUT TERMINATION

FIGURE 1A. LVPECL OUTPUT TERMINATION

ICS85320AMILF Datenblatt(PDF) 7 Page - Integrated Device Technology