466130 datasheet(9/36 Pages) ATMEL

9 / 36 page

7593JS–AVR–03/09

ATmega32U6/AT90USB64/128

2.2.18

XTAL2

Output from the inverting Oscillator amplifier.

2.2.19

AVCC

AVCC is the supply voltage pin for Port F and the A/D Converter. It should be externally con-

nected to V

CC, even if the ADC is not used. If the ADC is used, it should be connected to VCC

through a low-pass filter.

2.2.20

AREF

This is the analog reference pin for the A/D Converter.

About Code Examples

This documentation contains simple code examples that briefly show how to use various parts of

the device. Be aware that not all C compiler vendors include bit definitions in the header files

and interrupt handling in C is compiler dependent. Please confirm with the C compiler documen-

tation for more details.

These code examples assume that the part specific header file is included before compilation.

For I/O registers located in extended I/O map, "IN", "OUT", "SBIS", "SBIC", "CBI", and "SBI"

instructions must be replaced with instructions that allow access to extended I/O. Typically

"LDS" and "STS" combined with "SBRS", "SBRC", "SBR", and "CBR".

466130 Datenblatt(PDF) 9 Page - ATMEL Corporation