USB2512AI datasheet(23/63 Pages) MICROCHIP

23 / 63 page

USB 2.0 Hi-Speed Hub Controller

Datasheet

SMSC USB251xB/xBi

Revision 2.2 (02-17-12)

DATASHEET

3.3.1.3

LED

If a strap pin’s buffer type is I/O and shares functionality with an LED, the hardware configuration

outlined below must be implemented. The internal logic will drive the LED appropriately (active high or

low) depending on the sampled strap option. Use the Strap High configuration to set the strap option

value to 1 and Strap Low to set the strap option to 0.

Figure 3.6 LED Pin Strap Example

3.4

Buffer Type Descriptions

Table 3.5 Buffer Type Descriptions

BUFFER TYPE

DESCRIPTION

Input

I/O

Input/output

IPD

Input with internal weak pull-down resistor

IPU

Input with internal weak pull-up resistor

Input with Schmitt trigger

O12

Output 12 mA

I/O12

Input/output buffer with 12 mA sink and 12 mA source

I/OSD12

Open drain with Schmitt trigger and 12 mA sink. Meets the I2C-Bus

Specification [2] requirements.

ICLKx

XTAL clock input

OCLKx

XTAL clock output

I-R

RBIAS

I/O-U

Analog input/output defined in USB specification

HUB

Strap Pin

LED/

Strap High

Strap Pin

LED/

Strap Low

USB2512AI Datenblatt(PDF) 23 Page - Microchip Technology

USB2512AI Datenblatt(HTML) 23 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

Datenblatt Download

Link URL