LM92

www.ti.com

SNIS110D – MARCH 2000 – REVISED MARCH 2013

DEFAULT SETTINGS

The LM92 always powers up in a known state. LM92 power up default conditions are:

1. Comparator Interrupt Mode

4. T_CRIT set to 80 °C

6. INT and T_CRIT_A active low

7. Pointer set to “00”; Temperature Register

The LM92 registers will always reset to these default values when the power supply voltage is brought up from

zero volts as the supply crosses the voltage level plotted in the following curve. The LM92 registers will reset

again when the power supply drops below the voltage plotted in this curve.

Figure 6. Average Power on Reset Voltage vs Temperature

SERIAL BUS INTERFACE

The LM92 operates as a slave on the Serial Bus, so the SCL line is an input (no clock is generated by the LM92)

and the SDA line is a bi-directional serial data line. According to Serial Bus specifications, the LM92 has a 7-bit

slave address. The five most significant bits of the slave address are hard wired inside the LM92 and are

“10010”. The two least significant bits of the address are assigned to pins A1–A0, and are set by connecting

Therefore, the complete slave address is:

1

0

0

1

0

A1

A0

MSB

LSB

Copyright © 2000–2013, Texas Instruments Incorporated

Submit Documentation Feedback

9

Product Folder Links: LM92