PAGE

9

OF

9

TITLE :

台達電子工業股份有限公司

台達電子工業股份有限公司

台達電子工業股份有限公司

台達電子工業股份有限公司

Delta Electronics, Inc.

DOCUMENT

NO.

SRK330000NH

PAGE

REV.

A0

THIS DRAWINGS AND SPECIFICATIONS ARE THE PROPERTY OF Delta Electronics, Inc.

AND SHALL NOT BE REPRODUCED OR USED AS THE BASIS FOR THE MANUFACTURE OR SALE OF APPARATUS OR DEVICES WITHOUT PERMISSION

UNLESS OTHERWISE SPECIFIED TOLERANCES ON ﹕

X

= ±

X.X

= ±

X.XX

= ±

ANGLES ±

HOLE DIA. ±

SCALE :

UNIT :

The Engineering Specification for RLT0816

1/4W Low Resistance Chip Resistor

8. Carenote

8-1 Care note for storage

(1) Chip resistor shall be stored in a room where temperature and humidity must be controlled.

(temperature 5 to 35℃, humidity 45 to 85% RH) However, a humidity keep it low, as it is

possible.

(2) Chip resistor shall be stored as direct sunshine doesn’t hit on it.

(3) Chip resistor shall be stored with no moisture, dust, a material that will make solderability

inferior, and a harmful gas (Chloridation hydrogen, sulfurous acid gas, and sulfuration

hydrogen)

8-2 Carenote for operating and handling

(1) It is necessary to protect the edge and protection coat of resistors from mechanical stress.

(2) Handle with care when printing circuit board (PCB) is divided or fixed on support body,

because bending of printing circuit board (PCB) mounting will make mechanical stress for

resistors.

(3) Resistors shall be used with in rated range shown in specification. Especially, if voltage

more than specified value will be loaded to resistor, there is a case it will make damage for

machine because of temperature rise depending on generating of heat, and increase

resistance value or breaks.

(4) In case that resistor is loaded a rated voltage, it is necessary to confirms temperature of a

resistor and to reduce a load power according to load reduction curve, because a

temperature rise of a resistor depends on influence of heat from mounting density and

neighboring element.

(5) Observe Limiting element voltage and maximum overload voltage specified in each

specification

(6) If there is possibility that a large voltage (pulse voltage, shock voltage) charge to resistor, it

is necessary that operating condition shall be set up before use.