AM7969-125JC datasheet(92/127 Pages) AMD

92 / 127 page

AMD

TAXIchip Integrated Circuits Technical Manual

This serves to flush all extraneous data from the buffers and reset all internal state

machines. Once this is completed the Transmitter may be Strobed. X1 should be left in

the LOW state upon completion of the initialization.

The STRB input must now be strobed only once every n = 10 bitclk pulses or more. This

will allow time for an 8 bit wide byte to be encoded to 10 bits and shifted out one bit

every clock pulse.

The parallel data input pins are provided with new data every 10 bitclk pulses. Setup

and hold times remain the same as in non-Test Mode with respect to STRB. (In the

non-Test modes, the clock rate is the byte rate and a new data word and a strobe is

provided every clock pulse. In test mode, the clock rate is the bit rate so the new data

word and strobe are provided every

n clock pulses).

In Test Mode the Receiver expects only single ended data. Thus only one of the

SEROUT lines from the Transmitter is used. However, both lines must have pulldown

resistors to electrically balance the outputs.

Figure 8-1

Transmitter Test Mode Connections

ACK

STROBE

Data IN

8, 9, 10

Command IN

4, 3, 2

SEROUT+

SEROUT–

RESET

CLK

CLS

DMS

300

Ω

N/C = Test Mode

Bit Rate

Clock

Generator

Divide By n

or Byte Rate

Clock

Am7968

N/C

TLS

300

Ω

Media Interface

Can Be Set

for 8, 9, or

10-Bit Mode

To Receiver

12330E-35

AM7969-125JC Datenblatt(PDF) 92 Page - Advanced Micro Devices

AM7969-125JC Datenblatt(HTML) 92 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datenblatt Download

Link URL