W25Q40BLSVIP datasheet(39/74 Pages) WINBOND

39 / 74 page

W25Q40BL

Publication Release Date: May 04, 2012

- 39 -

Revision D

7.2.22 Quad Input Page Program (32h)

The Quad Page Program instruction allows up to 256 bytes of data to be programmed at previously

erased (FFh) memory locations using four pins: IO0, IO1, IO2, and IO3. The Quad Page Program can

improve performance for PROM Programmer and applications that have slow clock speeds <5MHz.

Systems with faster clock speed will not realize much benefit for the Quad Page Program instruction since

the inherent page program time is much greater than the time it take to clock-in the data.

To use Quad Page Program the Quad Enable in Status Register-2 must be set (QE=1). A Write Enable

instruction must be executed before the device will accept the Quad Page Program instruction (Status

“32h” followed by a 24-bit address (A23-A0) and at least one data byte, into the IO pins. The /CS pin must

be held low for the entire length of the instruction while data is being sent to the device. All other functions

of Quad Page Program are identical to standard Page Program. The Quad Page Program instruction

sequence is shown in figure 20.

Figure 20. Quad Input Page Program Instruction Sequence Diagram

W25Q40BLSVIP Datenblatt(PDF) 39 Page - Winbond