| Datenblatt-Suchmaschine für elektronische Bauteile |
|
AS3543 Datenblatt(PDF) 48 Page - ams AG |
|
|
|||||||||||||||||||||||||||||
AS3543 Datenblatt(HTML) 48 Page - ams AG |
|
48 / 92 page ![]() www.austriamicrosystems.com Revision 1.11 47 - 91 AS3543 3v2 Data Sheet - D e t a i l e d D e s c r i p t i o n - S Y S T E M F u n c t i o n s STATUS CHANGE The IRQ gets active when the source-state changes. The change bit and the status can be read to notice which inter- rupt was the source. The IRQ stays active until the corresponding interrupt register gets read. 10.4.3 De-bouncer There is a de-bounce function implemented for USB and CHARGER. Since these 2 signals can be unstable for the phase of plug-in or unplug, a de-bounce time of 512ms/256ms/128ms/8ms can be selected by 2 bits in the IRQ_ENRD_4 register (27h). 10.4.4 Interrupt Sources 26 IRQ events will activate the XIRQ pin: Headphone connected Headphone over-current Microphone connected Microphone remote control Voice activation threshold reached RTC sec/min elapsed 10bit ADC end of conversion I²S changed (active/inactive) USB changed (connect/disconnect) Charger changed (end of charge or connect/disconnect) Battery temperature high (at 45ºC or 55ºC with 100k Ω NTC) Junction temperature high RTC watchdog (e.g. after battery was changed) Battery low (Brown-out voltage reached) Wake-up from hibernation Power-up key (pin PWRUP) pressed Power rail monitor: over-voltage PVDD1, PVDD2, CVDD1, CVDD2, DCDC15 Power rail monitor: under-voltage PVDD1, PVDD2, CVDD1, CVDD2, AVDD27 10.4.5 Register Description Table 35. Interrupt Related Register Name Base Offset Description Out_Cntr3 2-wire serial 1A-3h Control of XIRQ signal, polarity and drive PMU_Enable 2-wire serial 1Ch Enables writings to extended register 1Ah-3 and 1Ah-5 IRQENRD_0 2-wire serial 23h Enable/disable PMU interrupts IRQENRD_1 2-wire serial 24h Enable/disable wake-up, voice and PMU interrupts IRQENRD_2 2-wire serial 25h Enable/disable charger, USB and supervisor interrupts IRQENRD_3 2-wire serial 26h Enable/disable junction temperature, headphone, microphone and I2S interrupt IRQENRD_4 2-wire serial 27h Enable/disable PMU, RTC, ADC10 and microphone interrupt, set VBUS and CHGIN debounce time |
|
Link URL |
| War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Link zum Datenblatt | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |