AS5261

Datasheet - Detailed Descr i p ti on

www.ams.com

Revision 1.1

10 - 32

8.2.3 Application Specific Programming of the Break Point

The break point BP can be programmed as well with 14 bits. This is important when the default transition point is inside the application range. In

such a case the default transition point must be shifted out of the application range. The parameter BP defines the new position.

Figure 5. Individual Programming of the Break Point BP

8.2.4 Multiple Slope Output

The AS5261 can be programmed to multiple slopes. Where one programmed reference slope characteristic is copied to multiple slopes. Two,

three and four slopes are selectable by the user OTP bits QUADEN (1:0). In addition to the steepness of the slope the clamping levels can be

programmed as well.

Figure 6. Two Slope Mode

0

100 % DC

360