TDA7370BV datasheet(10/17 Pages) STMICROELECTRONICS

Teilenummer	TDA7370BV

Bauteilbeschribung	QUAD POWER AMPLIFIER FOR CAR RADIO

Download	17 Pages

Scroll/Zoom	100%

Hersteller	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

10 / 17 page

OUTPUT STAGE

The fully complementary output stage was made

possible by the development of a new compo-

nent: the ST exclusive power ICV PNP.

A novel design based upon the connection shown

in fig. 19 has then allowed the full exploitation of

its possibilities.

The clear advantages this new approach has over

classical output stages are as follows:

1 - Rail-to-Rail Output Voltage Swing With No

Need Of Bootstrap Capacitors.

The output swing is limited only by the Vcesat of

the output transistors, which are in the range of

0.6 Ohm (Rsat) each.

Classical solutions adopting composite PNP-NPN

for the upper output stage have higher saturation

loss on the top side of the waveform. This unbal-

anced saturation causes a significant power re-

duction. The only way to recover power consists

of the addition of expensive bootstrap capacitors.

2 - Absolute Stability Without Any External

Compensation.

Referring to the circuit of Fig. 19

the gain

VOUT/VIN is greater than unity, approximately 1 +

R2/R1. The DC output (VCC/2) is fixed by an aux-

iliary amplifier common to all the channels).

By controlling the amount of this local feedback it

is possible to force the loop gain (A *

β) to less

than unity at frequency for which the phase shift

is 180 Deg. This means that the output buffer is

intrinsically stable and not prone to oscillation.

Most remarkably, the above feature has been

achieved in spite of the very low closed loop gain

of the amplifier (20 dB).

In contrast, with the classical PNP-NPN stage,

the solution adopted for reducing the gain at high

frequencies makes use of external RC networks,

namely the Boucherot cells.

OTHER OUTSTANDING CHARACTERISTICS:

Clipping Detector Output

The TDA7370B is equipped with an internal cir-

cuit able to detect the output stage saturation pro-

viding a current sinking into a open collector out-

put (pin 10) when a certain distortion level is

reached at each output.

This particular function allows gain compression

facility whenever the amplifier is overdriven, thus

obtaining high quality sound at all listening levels.

Figure 19: The new Output Stage

Figure 20: Clipping Detection Waveforms

TDA7370B

10/17

Obsolete

Product(s)

- Obsolete

Product(s)

Ähnliche Beschreibung - TDA7370BV

Hersteller	Teilenummer	Datenblatt	Bauteilbeschribung
STMicroelectronics	TDA7370	259Kb / 17P	QUAD POWER AMPLIFIER FOR CAR RADIO
STMicroelectronics	TDA7370B	259Kb / 17P	QUAD POWER AMPLIFIER FOR CAR RADIO
Unisonic Technologies	TDA7377	349Kb / 10P	30W DUAL/QUAD POWER AMPLIFIER FOR CAR RADIO
Unisonic Technologies	TDA7388	207Kb / 5P	QUAD BRIDGE CAR RADIO AMPLIFIER
STMicroelectronics	TDA7377	254Kb / 10P	2 x 30WDUAL/QUAD POWER AMPLIFIER FOR CAR RADIO
List of Unclassifed Man...	YD7377	272Kb / 10P	2 x 30WDUAL/QUAD POWER AMPLIFIER FOR CAR RADIO September 1998
Unisonic Technologies	PA7375	401Kb / 10P	2 x 35W DUAL/QUAD POWER AMPLIFIER FOR CAR RADIO
Unisonic Technologies	TDA7377	311Kb / 8P	2 x 30W DUAL/QUAD POWER AMPLIFIER FOR CAR RADIO
STMicroelectronics	E-TDA7375V	299Kb / 15P	2 x 35W dual/quad power amplifier for car radio September 2013 Rev. 5
STMicroelectronics	TDA7375	201Kb / 15P	2 x 35W DUAL/QUAD POWER AMPLIFIER FOR CAR RADIO

More results

TDA7370BV Datenblatt(PDF) 10 Page - STMicroelectronics

TDA7370BV Datenblatt(HTML) 10 Page - STMicroelectronics

Ähnliche Teilenummer - TDA7370BV

Ähnliche Beschreibung - TDA7370BV

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Datenblatt Download

Link URL