RM0352 datasheet(56/138 Pages) STMICROELECTRONICS

56 / 138 page

ARM© dual timer module (SP804)

RM0352

56/138

DocID024647 Rev 1

Figure 11 illustrates an example of the timing for an interrupt being raised and cleared.

Figure 11. Example interrupt signal timing

The interrupt signals generated by the timer module, TIMINT1 and TIMINT2, can be

masked by setting the IntEnable bit to 0 in the TimerXControl register. The raw interrupt

status prior to masking can be read from the TimerXRIS register and the masked interrupt

status can be read from the TimerXMIS register.

Figure 12 shows how the raw and masked

interrupt status is accessed.

Figure 12. Raw and masked interrupt status

Programming the timer interval

Table 51 shows the equations that are used to calculate the timer interval generated for

each timer mode in terms of:

•

TIMCLKFREQ is the frequency of TIMCLK.15

•

TIMCLKENXDIV is the effective division of the TIMCLK rate by the clock enable,

TIMCLKENX. For example, if TIMCLKENX enables every fourth TIMCLK edge then

TIMCLKENXDIV = 4.

•

PRESCALEDIV is the prescaler division factor of 1, 16, or 256. Derived from

•

Control register bits [3:2].

•

TimerXLoad is the value in the load register.

RM0352 Datenblatt(PDF) 56 Page - STMicroelectronics