| Datenblatt-Suchmaschine für elektronische Bauteile |
|
PM0056 Datenblatt(PDF) 42 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
PM0056 Datenblatt(HTML) 42 Page - STMicroelectronics |
|
42 / 156 page ![]() The Cortex-M3 processor PM0056 42/156 DocID15491 Rev 5 2.4.3 Fault status registers and fault address registers The fault status registers indicate the cause of a fault. For bus faults and memory management faults, the fault address register indicates the address accessed by the operation that caused the fault, as shown in Table 19. 2.4.4 Lockup The processor enters a lockup state if a hard fault occurs when executing the NMI or hard fault handlers. When the processor is in lockup state it does not execute any instructions. The processor remains in lockup state until either: • It is reset • An NMI occurs If lockup state occurs from the NMI handler a subsequent NMI does not cause the processor to leave lockup state. 2.5 Power management The STM32 and Cortex-M3 processor sleep modes reduce power consumption: • Sleep mode stops the processor clock. All other system and peripheral clocks may still be running. • Deep sleep mode stops most of the STM32 system and peripheral clocks. At product level, this corresponds to either the Stop or the Standby mode. For more details, please refer to the “Power modes” Section in the STM32 reference manual. The SLEEPDEEP bit of the SCR selects which sleep mode is used, see System control register (SCB_SCR) on page 136. For more information about the behavior of the sleep modes see the STM32 product reference manual. This section describes the mechanisms for entering sleep mode, and the conditions for waking up from sleep mode. Table 19. Fault status and fault address registers Handler Status register name Address register name Register description Hard fault HFSR - Hard fault status register (SCB_HFSR) on page 145 Memory management fault MMFSR MMFAR Configurable fault status register (SCB_CFSR) on page 142 Memory management fault address register (SCB_MMFAR) on page 147 Bus fault BFSR BFAR Configurable fault status register (SCB_CFSR) on page 142 Bus fault address register (SCB_BFAR) on page 147 Usage fault UFSR - Configurable fault status register (SCB_CFSR) on page 142 |
|
Link URL |
| War ALLDATASHEET hilfreich? [ DONATE ] |
Über Alldatasheet | Werbung | Kontakt | Privatsphäre und Datenschutz | Link zum Datenblatt | Linktausch | Hersteller All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |