US1528XG-S08-R datasheet(6/8 Pages) UTC

6 / 8 page

US1528

Preliminary

CMOS IC

UNISONICTECHNOLOGIESCO.,LTD

6 of 8

www.unisonic.com.tw

QW-R502-457.b

APPLICATIONS INFORMATION

Supply Filtering

In order to control supply transients, a bypass capacitor is located nearly between IN to GND. 0.1µF ~ 1µF is

suitable (See Figure 1). Without a bypass capacitor, an output short may cause sufficient ringing on the input (from

supply lead inductance) to damage internal control circuitry.

Input transients must not exceed the absolute maximum supply voltage (VIN Max = 6V) even for a short duration.

/EN , The Active-High/Low Enable Input

For a clearly defined input, the EN/EN pin, with 0.2V hysteresis, must be driven logic high or logic low. Floating

the input may cause unpredictable operation. EN/EN should not be allowed to go negative with respect to GND.

Soft Start

The UTC US1528 is high impedance when off and slowly becomes a low impedance as it turns on. This

reduces inrush current and related voltage drop that results from charging a capacitive load, satisfying the USB

voltage drop requirements, for bus-powered applications as shown in Figure 2.

US1528XG-S08-R Datenblatt(PDF) 6 Page - Unisonic Technologies