USB3320 datasheet(20/70 Pages) MICROCHIP

20 / 70 page

USB3320

DS00001792B-page 20

 2014-2015 Microchip Technology Inc.

The system must not drive voltage on the CLKOUT pin following POR or hardware reset that exceeds the value of

VIH_ED provided in Table 4-4.

5.4.1.1

ULPI Input Clock Mode (60MHz REFCLK Mode)

When using ULPI Input Clock Mode, the Link must supply the 60MHz ULPI clock to the USB3320. As shown in Figure 5-

2, the 60MHz ULPI Clock is connected to the REFCLK pin, and the CLKOUT pin is tied high to VDDIO. A simplified

schematic using the ULPI Input Clock Mode is shown in Figure 8-2.

After the PLL has locked to the correct frequency, the USB3320 will de-assert DIR and the Link can begin using the

ULPI interface. The USB3320 is ensured to start the clock within the time specified in Table 4-2. For Host applications,

the ULPI AutoResume bit should be enabled. This is described in Section 6.2.4.4.

REFSEL[2]

, REFSEL[1] and REFSEL[0] should all be tied to VDDIO for ULPI Input Clock Mode.

5.4.1.2

ULPI Output Clock

When using ULPI Output Clock Mode, the USB3320 generates the 60MHz ULPI clock used by the Link. The frequency

of the reference clock is configured by REFSEL[2], REFSEL[1] and REFSEL[0] as described in Table 5-10. As shown

in Figure 5-3, the CLKOUT pin sources the 60MHz ULPI clock to the Link.

FIGURE 5-2:

CONFIGURING THE USB332X FOR ULPI INPUT CLOCK MODE (60 MHZ)

FIGURE 5-3:

CONFIGURING THE USB332X FOR ULPI OUTPUT CLOCK MODE

CLKOUT

REFCLK

PHY

Clock

Source

To PLL

Link

ULPI Clk Out

Reference Clk In

VDDIO

CLKOUT

REFCLK

PHY

From PLL

Clock

Source

To PLL

Link

ULPI Clk In

USB3320 Datenblatt(PDF) 20 Page - Microchip Technology

USB3320 Datenblatt(HTML) 20 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70

Datenblatt Download

Link URL