EMC1187 datasheet(41/47 Pages) MICROCHIP

41 / 47 page

Triple Channel 1°C Temperature Sensor with Hardware Thermal Shutdown and 1.8V SMBus Communications

Datasheet

SMSC EMC1187

Revision 1.0 (07-11-13)

DATASHEET

The ALERT pin will be set if the programmed number of consecutive alert counts have been met and

any of these status bits are set.

The status bits will remain set until read unless the ALERT pin is configured as a comparator output

(see Section 5.5.2).

Bit 2 - E2LOW - This bit is set when the External Diode 2 channel drops below its programmed low

limit.

Bit 1 - E1LOW - This bit is set when the External Diode 1 channel drops below its programmed low

limit.

Bit 0 - ILOW - This bit is set when the Internal Diode channel drops below its programmed low limit.

6.18

Therm Limit Status Register 37h

The Therm Limit Status Register contains the status bits that are set when a temperature channel

Therm Limit is exceeded. If any of these bits are set, the THERM status bit in the Status Register is

set. Reading from the Therm Limit Status Register will not clear the status bits. Once the temperature

drops below the Therm Limit minus the Therm Hysteresis, the corresponding status bits will be

automatically cleared. The THERM bit in the Status Register will be cleared when all individual channel

THERM bits are cleared.

Bit 2 - E2THERM - This bit is set when the External Diode 2 channel exceeds its programmed Therm

Limit. When set, this bit will assert the THERM pin.

Bit 1 - E1THERM - This bit is set when the External Diode 1 channel exceeds its programmed Therm

Limit. When set, this bit will assert the THERM pin.

Bit 0- ITHERM - This bit is set when the Internal Diode channel exceeds its programmed Therm Limit.

When set, this bit will assert the THERM pin.

6.19

Filter Control Register 40h

The Filter Configuration Register controls the digital filter on the External Diode channel.

Bits 1-0 - FILTER[1:0] - Control the level of digital filtering that is applied to the External Diode

temperature measurement as shown in Table 6.25. See Figure 5.4 and Figure 5.5 for examples on the

filter behavior.

Table 6.23 Therm Limit Status Register

ADDR.

R/W

DEFAULT

37h

R-C

Therm

Limit

Status

THERM

ITHERM

00h

Table 6.24 Filter Configuration Register

ADDR.

R/W

DEFAULT

40h

R/W

Filter Control

FILTER[1:0]

00h

EMC1187 Datenblatt(PDF) 41 Page - Microchip Technology

EMC1187 Datenblatt(HTML) 41 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47

Datenblatt Download

Link URL