M95M02-DR datasheet(30/45 Pages) STMICROELECTRONICS

Teilenummer	M95M02-DR

Bauteilbeschribung	2-Mbit serial SPI bus EEPROM

PDF	45 Pages

Scroll/Zoom	100%

Hersteller	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

30 / 45 page

Power-up and delivery state

M95M02-DR

30/45

DocID18203 Rev 10

Power-up and delivery state

7.1

Power-up state

After power-up, the device is in the following state:

•

Standby power mode,

•

deselected (after power-up, a falling edge is required on Chip Select (S) before any

instructions can be started),

•

not in the Hold condition,

•

the Write Enable Latch (WEL) is reset to 0,

•

Write In Progress (WIP) is reset to 0.

The SRWD, BP1 and BP0 bits of the Status Register are unchanged from the previous

power-down (they are non-volatile bits).

7.2

Initial delivery state

The device is delivered with the memory array bits and identification page bits set to all 1s

(each byte = FFh). The Status Register Write Disable (SRWD) and Block Protect (BP1 and

BP0) bits are initialized to 0.

M95M02-DR Datenblatt(PDF) 30 Page - STMicroelectronics