WS9445P datasheet(6/9 Pages) WINSEMI

6 / 9 page

www.winsemi.com

Tel : +86-755-8250 6288

Fax : +86-755-8250 6299

6/9

WS9445P Product Description

WINSEMI MICROELECTRONICS

External PWM Dimming

The WS9445P integrates an external dimming pin which

inputs PWM signal and can dim by changing the duty cycle

of the PWM signal. The testing dimmable curve of a

120V/260mA driver under 175~264Vac application is shown

as below:

The duty cycle of the PWM signal

Inductor Selection

The WS9445P works in a inductor critical current

conduction mode. When the power MOFET is switched on,

the current in the inductor rises up from zero. The on time of

the MOSFET can be calculated by the equation:

LED







Where,

L is the inductance value,

IPK is the peak current of the inductor,

VIN is the DC bus voltage after the rectifier bridge,

VLED is the voltage on the LED.

After the power MOSFET is also switched off and the

current in the inductor decreases. When the inductor current

reaches zero, the power MOSFET is turned on again by IC

internal logic. The off time of the MOSFET is given by the

equation:

LED

off





The inductance can be calculated by the equati

on:

LED









)

(

Where, f is the maximum system switching frequency,

which is proportional to the input voltage. So the minimum

switching frequency is set at lowest input voltage, and the

maximum switching frequency is set at highest input voltage.

The minimum and maximum off time of WS9445P is set at

4.5us and 310us, respectively. Referring to the equation of Toff

calculation, if the inductance is too small, the Toff may be

smaller than the minimum off time, the system will operate in

discontinuous conduction mode and the output current will be

smaller than the designed value. If the inductance is too large,

the Toff may be larger than the maximum off time, the system

will operate in continuous conduction mode and the output

current will be higher than the designed value. So it is

important to choose a proper inductance.

Thermal Regulation

The WS9445P integrates thermal regulation function.

When the system is under higher temperature, the output

current is gradually reduced; the output power and thermal

dissipation are also reduced. The system temperature is

regulated and the system reliability is improved. The thermal

regulation temperature is set to 150℃ internally.

Over Voltage Protection

The over voltage protection of the WS9445P can be

programmed by the ROVP pin resistor. The ROVP pin voltage

is 0.5V.

When the LED is open circuit, the period of the output

voltage increases gradually, the demagnetization time gets

shorter. The demagnetization time at OVP---- Tovp can be

calculated by the open circuit protection voltage by the

equation:

OVP

Tovp





Where，

Vcs is the CS pin turn off threshold (0.4V);

Vovp is the open circuit protection voltage.

And then the Rovp resistor value can be calculated by the

equation:

WS9445P Datenblatt(PDF) 6 Page - Shenzhen Winsemi Microelectronics Co., Ltd

WS9445P Datenblatt(HTML) 6 Page - Shenzhen Winsemi Microelectronics Co., Ltd

Html Pages

1 2 3 4 5 6 7 8 9

Datenblatt Download

Link URL