STM32F303VB datasheet(43/148 Pages) STMICROELECTRONICS

Teilenummer	STM32F303VB

Bauteilbeschribung	ARM®-based Cortex®-M4 32b MCUFPU, up to 256KB Flash 48KB SRAM, 4 ADCs, 2 DAC ch., 7 comp, 4 PGA, timers, 2.0-3.6 V

PDF	148 Pages

Scroll/Zoom	100%

Hersteller	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

43 / 148 page

DocID023353 Rev 13

43/148

STM32F303xB STM32F303xC

Pinouts and pin description

1. Function availability depends on the chosen device.

When using the small packages (48 and 64 pin packages), the GPIO pins which are not present on these packages, must

not be configured in analog mode.

2. PC13, PC14 and PC15 are supplied through the power switch. Since the switch sinks only a limited amount of current

(3 mA), the use of GPIO PC13 to PC15 in output mode is limited:

- The speed should not exceed 2 MHz with a maximum load of 30 pF

- These GPIOs must not be used as current sources (e.g. to drive an LED).

After the first backup domain power-up, PC13, PC14 and PC15 operate as GPIOs. Their function then depends on the

content of the Backup registers which is not reset by the main reset. For details on how to manage these GPIOs, refer to

the Battery backup domain and BKP register description sections in the RM0316 reference manual.

3. The VREF+ functionality is available only on the 100 pin package. On the 64-pin and 48-pin packages, the VREF+ is

internally connected to VDDA.

4. Fast ADC channel.

5. These GPIOs offer a reduced touch sensing sensitivity. It is thus recommended to use them as sampling capacitor I/O.

STM32F303VB Datenblatt(PDF) 43 Page - STMicroelectronics