1215708 datasheet(3/10 Pages) SICK

3 / 10 page

C4P-SA07510A001200, C4P-EA07510A001200 | deTec4 Prime

SAFETY LIGHT CURTAINS

Functions

Delivery status

Restart interlock

✔

Deactivated

External device monitoring (EDM)

✔

Deactivated

Beam coding

✔

Uncoded

Automatic calibration of the protective field

width

✔

Interfaces

System connection

Connection type Male connector M12, 8-pin

Sender/receiver communication (COM1) ✔ 1)

Reset pushbutton input (RES) ✔ 2)

External device monitoring input (EDM) ✔ 2)

Application diagnostic output (ADO) ✔ 2)

Permitted cable length Receiver power supply: 15 m 3)

All additional conductors at the system connection: 37.5 m

Configuration method

Cascade Automatic detection when starting the device

External device monitoring (EDM) Automatic detection when starting the device

Calibration of the protective field width Automatic detection when starting the device

Restart interlock Teach-in procedure when starting the device

Beam coding DIP switch

Reset to factory default DIP switch

Status display

LEDs

Fieldbus, industrial network

Integration via Flexi Soft safety controller CANopen, DeviceNet™, EtherCAT®, EtherNet/IP™, Modbus TCP, PROFIBUS DP, PROFINET 4)

1) Optional: To indicate the status on both sides, the COM1 connections from the sender and receiver must be connected to each other in the control cabinet.

2) Only on the receiver.

3) If no inductive OSSD loads (e.g., contactors) are in use, the power supply cable for the receiver of a single device (no cascade) can be up to 30 m in length.

4) For additional information on Flexi Soft -> www.sick.com/Flexi_Soft.

Electrical data

Protection class

III (EN 50178) 1)

Supply voltage VS

24 V DC (19.2 V DC ... 28.8 V DC)

Ripple

≤ 10 % 2)

Power consumption typical

3.93 W (DC) / 1.68 W (DC) (depending on type)

Safety outputs (OSSD)

Type of output 2 PNP semiconductors, short-circuit protected, cross-circuit monitored 3)

Switching voltage HIGH 24 V DC (VS – 2.25 V DC ... VS)

Switching voltage LOW ≤ 2 V DC

1) SELV/PELV safety/protective extra-low voltage.

2) Within the limits of VS.

3) Applies to the voltage range between –30 V and +30 V.

2017-08-21 16:38:06 | Online data sheet

Subject to change without notice

OPTO-ELECTRONIC PROTECTIVE DEVICES | SICK

1215708 Datenblatt(PDF) 3 Page - SICK AG

1215708 Datenblatt(HTML) 3 Page - SICK AG

Html Pages

1 2 3 4 5 6 7 8 9 10

Datenblatt Download

Link URL