www.roithner-laser.com

2

Outline Dimensions

All Dimensions in mm

Precautions

Cautions:

DO NOT look directly into the emitted light or look through the optical system. To prevent in adequate

exposure of the radiation, wear protective glasses.

Operation:

• Check your connection circuits before turning on the LED

• Mind the LED polarity: LED anode is marked by long pin

• Do only operate LEDs with a current source

Soldering:

• Do avoid electrostatic discharge (ESD)

• Do avoid mechanical stress, shock, and vibration

• Do only use non-corrosive flux

• Do only cut the leads at room temperature with an ESD protected tool

• Do not solder closer than 3 mm from base of the header

• Do form leads prior to soldering

• Do not impose mechanical stress on the header when forming the leads

• Do not apply current to the LED until it has cooled down to room temperature after soldering

Static Electricity:

LEDs are sensitive to electrostatic discharge (ESD). Precautions against ESD must be taken

when handling or operating these LEDs. Surge voltage or electrostatic discharge can result in

complete failure of the device.

© All Rights Reserved

The above specifications are for reference purpose only and subjected to change without prior notice

ELD-900-525

5 mm epoxy