AC244036 datasheet(5/78 Pages) MICROCHIP

5 / 78 page

Debug Header Specification

 2006-2012 Microchip Technology Inc.

DS51292T-page 5

FIGURE 4:

CONNECT HEADER TO DEBUG TOOL

Connect the header to the target board. On the bottom of the header is a socket

that is used to connect to the target board. The header may be connected to the

target board as follows:

a) PDIP header socket to PDIP target socket with a stand-off (male-to-male)

connector

b) Header socket to plug on the target board

Header socket to target socket with a transition socket (see the “Transition

Socket Specification”, DS51194)

An example connection is shown in Figure 5.

The header socket will have the same pin count as your selected device. The

ICE/ICD device on the top of the header usually has a larger pin count because

it has additional pins that are dedicated to debug.

FIGURE 5:

CONNECT HEADER TO TARGET

If using a debug tool that can power the target, power that tool now.

Power the target, if needed.

Debug Header (Top)

ICE/ICD Device

Debug Tool Module

(Top)

To PC and

MPLAB® IDE

Power In

Target Board (Top)

Target Socket

Stand-off Connector

Debug Header (Bottom)

Header Socket

AC244036 Datenblatt(PDF) 5 Page - Microchip Technology