AM263P4 datasheet(14/154 Pages) TI

14 / 154 page

Note

Configuring two pins to the same pin multiplexed signal function is not supported as this yields

unexpected results. Issues can be easily prevented with the proper software configuration.

When a pad is set into a multiplexing mode which is not defined by pin multiplexing, that pad’s

behavior is undefined. This must be avoided.

13. Buffer Type: This column defines the buffer type associated with a terminal. This information can be used to

determine the applicable Electrical Characteristics table.

• An empty box, NA, or "-" means Not Applicable.

For electrical characteristics, refer to the appropriate buffer type table in Electrical Characteristics.

14. Pad Configuration Register Name: This is the name of the device pad/pin configuration register.

15. Pad Configuration Register Address: This is the memory address of the device pad/pin configuration

16. Pad Configuration Register Default Value: This is the default value of the register device pad/pin

configuration register after PORz is deasserted.

TI Information - Selective Disclosure

AM263P4, AM263P2, AM263P1, AM263P4-Q1, AM263P2-Q1, AM263P1-Q1

SPRSP81 – OCTOBER 2023

www.ti.com

Submit Document Feedback

AM263P4 Datenblatt(PDF) 14 Page - Texas Instruments