AM29LV128ML113REF datasheet(42/66 Pages) AMD

42 / 66 page

Am29LV128MH/L

25270C7 January 31, 2007

D A TA

SH EE T

other system tasks. In this case, the system must start

at the beginning of the algorithm when it returns to de-

termine the status of the operation (top of Figure 9).

DQ5: Exceeded Timing Limits

DQ5 indicates whether the program, erase, or

write-to-buffer time has exceeded a specified internal

pulse count limit. Under these conditions DQ5 produces a

“1,” indicating that the program or erase cycle was not suc-

cessfully completed.

The device may output a “1” on DQ5 if the system tries

to program a “1” to a location that was previously pro-

grammed to “0.” Only an erase operation can

change a “0” back to a “1.” Under this condition, the

device halts the operation, and when the timing limit

has been exceeded, DQ5 produces a “1.”

In all these cases, the system must write the reset

command to return the device to the reading the array

(or to erase-suspend-read if the device was previously

in the erase-suspend-program mode).

DQ3: Sector Erase Timer

After writing a sector erase command sequence, the

system may read DQ3 to determine whether or not

erasure has begun. (The sector erase timer does not

apply to the chip erase command.) If additional

sectors are selected for erasure, the entire time-out

also applies after each additional sector erase com-

mand. When the time-out period is complete, DQ3

switches from a “0” to a “1.” If the time between addi-

tional sector erase commands from the system can be

assumed to be less than 50 µs, the system need not

monitor DQ3. See “Sector Erase Command Se-

quence” on page 34.

After the sector erase command is written, the system

should read the status of DQ7 (Data# Polling) or DQ6

(Toggle Bit I) to ensure that the device has accepted

the command sequence, and then read DQ3. If DQ3 is

“1,” the Embedded Erase algorithm has begun; all fur-

ther commands (except Erase Suspend) are ignored

until the erase operation is complete. If DQ3 is “0,” the

device will accept additional sector erase commands.

To ensure the command has been accepted, the sys-

tem software should check the status of DQ3 prior to

and following each subsequent sector erase com-

mand. If DQ3 is high on the second status check, the

last command might not have been accepted.

Table 12 shows the status of DQ3 relative to the other

status bits.

DQ1: Write-to-Buffer Abort

DQ1 indicates whether a Write-to-Buffer operation

was aborted. Under these conditions DQ1 produces a

“1”.

The

system

m u st

i s s u e

the

Write-to-Buffer-Abort-Reset command sequence to re-

turn the device to reading array data. See “Write Buffer

Programming” on page 30 for more details.

AM29LV128ML113REF Datenblatt(PDF) 42 Page - Advanced Micro Devices

AM29LV128ML113REF Datenblatt(HTML) 42 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

Datenblatt Download

Link URL