TPIC6A595 Power Logic 8-Bit Shift Register

1 Features

• Low rDS(on): 1Ω (Typical)

• Output short-circuit protection

• Avalanche energy: 75mJ

• Eight 350mA DMOS outputs

• 50V switching capability

• Devices are cascadable

• Low power consumption

2 Applications

• Instrumentation Clusters

• Tell-Tale Lamps

• LED Illumination and Controls

• Automotive Relay or Solenoids Drivers

3 Description

The TPIC6A595 is a monolithic, high-voltage, high-

current power logic 8-bit shift register designed for

use in systems that require relatively high load power.

The device contains a built-in voltage clamp on

the outputs for inductive transient protection. Power

driver applications include relays, solenoids, and

other medium-current or high-voltage loads. Each

open-drain DMOS transistor features an independent

chopping current-limiting circuit to prevent damage in

the case of a short circuit.

This device contains an 8-bit serial-in, parallel-out

shift register that feeds an 8-bit, D-type storage

register. Data transfers through both the shift and

storage registers on the rising edge of the shift-

register clock (SRCK) and the register clock (RCK),

respectively. The storage register transfers data to

the output buffer when shift-register clear (SRCLR)

is high. Write data and read data are valid only

when RCK is low. When SRCLR is low, the input

shift register is cleared. When output enable (G) is

held high, all data in the output buffers is held low

and all drain outputs are off. When G is held low,

data from the storage register is transparent to the

output buffers. The serial output (SER OUT) allows

for cascading of the data from the shift register to

additional devices.

Outputs are low-side, open-drain DMOS transistors

with output ratings of 50V and a 350mA continuous

sink-current capability. When data in the output

buffers is low, the DMOS-transistor outputs are off.

When data is high, the DMOS-transistor outputs have

sink current capability.

Separate power ground (PGND) and logic ground

(LGND) terminals are provided to facilitate maximum

system flexibility. All PGND terminals are internally

connected, and each PGND terminal must be

externally connected to power system ground in

order to minimize parasitic impedence. A single-point

connection between LGND and PGND must be made

externally in a manner that reduces crosstalk between

the logic and load circuits.

The TPIC6A595 is offered in a thermally-enhanced

due-in-line

(NE)

package

and

a

wide-body

surface-mount (DW) package. The TPIC6A595 is

characterized for operating over the operating case

termperau range of -40 to 125°C.

Table 3-1. Device Information

PART MUMBER

PACKAGE

BODY SIZE(NOM)

TPIC6A595

PDIP(20)

24.00mm × 6.86mm

SOIC(24)

15.40mm × 7.50mm

This symbol is in accordance with ANSI/IEEE Std 91-1984 and

IEC Publication 617-12.

Logic Symbol

TPIC6A595

SLIS005C – APRIL 1993 – REVISED MARCH 2025

An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,

intellectual property matters and other important disclaimers. PRODUCTION DATA.