M306V2EEFS datasheet(49/271 Pages) RENESAS

49 / 271 page

Rev.1.40

Oct 06, 2004 page 49 of 269

M306V2ME-XXXFP, M306V2EEFP

2.7.3 Hardware Interrupts

Hardware interrupts are classified into two types — special interrupts and peripheral I/O interrupts.

(1) Special interrupts

Special interrupts are non-maskable interrupts.

• Reset

____________

Reset occurs if an “L” is input to the RESET pin.

________

• DBC interrupt

This interrupt is exclusively for the debugger, do not use it in other circumstances.

• Watchdog timer interrupt

Generated by the watchdog timer.

• Single-step interrupt

This interrupt is exclusively for the debugger, do not use it in other circumstances. With the debug

flag (D flag) set to “1,” a single-step interrupt occurs after one instruction is executed.

• Address match interrupt

An address match interrupt occurs immediately before the instruction held in the address indicated

by the address match interrupt register is executed with the address match interrupt enable bit set to

“1.” If an address other than the first address of the instruction in the address match interrupt register

is set, no address match interrupt occurs. For address match interrupt, see 2.11 Address match

Interrupt.

(2) Peripheral I/O interrupts

A peripheral I/O interrupt is generated by one of built-in peripheral functions. Built-in peripheral func-

tions are dependent on classes of products, so the interrupt factors too are dependent on classes of

products. The interrupt vector table is the same as the one for software interrupt numbers 0 through

31 the INI instruction uses. Peripheral I/O interrupts are maskable interrupts.

• Bus collision detection interrupt

This is an interrupt that the serial I/O bus collision detection generates.

• DMA0 interrupt, DMA1 interrupt

These are interrupts DMA generates.

• VSYNC interrupt

VSYNC interrupt occurs if a VSYNC edge is input.

• A-D conversion interrupt

This is an interrupt that the A-D converter generates.

• UART0 transmission, UART2 transmission interrupts

These are interrupts that the serial I/O transmission generates.

• UART0 reception, UART2 reception interrupts

These are interrupts that the serial I/O reception generates.

• Multi-master I2C-BUS interface 0 and multi-master I2C-BUS interface 1 interrupts

This is an interrupt that the serial I/O transmission/reception is completed, or a STOP condition is

detected.

• Timer A0 interrupt through timer A4 interrupt

These are interrupts that timer A generates

• Timer B0 interrupt through timer B2 interrupt

These are interrupts that timer B generates.

M306V2EEFS Datenblatt(PDF) 49 Page - Renesas Technology Corp

M306V2EEFS Datenblatt(HTML) 49 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datenblatt Download

Link URL