ATmega328P datasheet(4/345 Pages) ATMEL

4 / 345 page

7810A–AVR–11/09

ATmega328P [Preliminary]

1.1.7

CC is the supply voltage pin for the A/D Converter, PC3:0, and ADC7:6. It should be externally

connected to V

CC, even if the ADC is not used. If the ADC is used, it should be connected to VCC

through a low-pass filter. Note that PC6..4 use digital supply voltage, V

CC.

1.1.8

AREF

AREF is the analog reference pin for the A/D Converter.

1.1.9

ADC7:6 (TQFP and QFN/MLF Package Only)

In the TQFP and QFN/MLF package, ADC7:6 serve as analog inputs to the A/D converter.

These pins are powered from the analog supply and serve as 10-bit ADC channels.

1.2

Disclaimer

Typical values contained in this datasheet are based on simulations and characterization of

actual ATmega328P AVR microcontrollers manufactured on the typical process technology.

Automotive Min and Max values are based on characterization of actual ATmega328P AVR

microcontrollers manufactured on the whole process excursion (corner run).

1.3

Automotive Quality Grade

The ATmega328P have been developed and manufactured according to the most

stringent requirements of the international standard ISO-TS-16949. This data sheet contains

limit values extracted from the results of extensive characterization (Temperature and Voltage).

The quality and reliability of the ATmega328P have been verified during regular product

qualification as per AEC-Q100 grade 1.

As indicated in the ordering information paragraph, the products are available in only one tem-

perature grade.

Table 1-1.

Temperature Grade Identification for Automotive Products

Temperature

Temperature Identifier

Comments

-40°C ; +125°C

Full AutomotiveTemperature Range

ATmega328P Datenblatt(PDF) 4 Page - ATMEL Corporation