LPC1313 datasheet(21/60 Pages) NXP

21 / 60 page

LPC1311_13_42_43_2

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 02 — 6 May 2010

21 of 60

NXP Semiconductors

LPC1311/13/42/43

32-bit ARM Cortex-M3 microcontroller

• Four match registers per timer that allow:

– Continuous operation with optional interrupt generation on match.

– Stop timer on match with optional interrupt generation.

– Reset timer on match with optional interrupt generation.

• Up to four external outputs corresponding to match registers, with the following

capabilities:

– Set LOW on match.

– Set HIGH on match.

– Toggle on match.

– Do nothing on match.

7.15 System tick timer

The ARM Cortex-M3 includes a system tick timer (SYSTICK) that is intended to generate

a dedicated SYSTICK exception at a fixed time interval, normally set to 10 ms.

7.16 Watchdog timer

The purpose of the watchdog is to reset the microcontroller within a selectable time

period. When enabled, the watchdog will generate a system reset if the user program fails

to ‘feed’ (or reload) the watchdog within a predetermined amount of time.

7.16.1 Features

• Internally resets chip if not periodically reloaded.

• Debug mode.

• Enabled by software but requires a hardware reset or a watchdog reset/interrupt to be

disabled.

• Incorrect/incomplete feed sequence causes reset/interrupt if enabled.

• Flag to indicate watchdog reset.

• Programmable 32-bit timer with internal prescaler.

• Selectable time period from (Tcy(WDCLK) × 256 × 4) to (Tcy(WDCLK) × 232 × 4) in

multiples of Tcy(WDCLK) × 4.

• The Watchdog Clock (WDCLK) source can be selected from the Internal RC oscillator

(IRC), the watchdog oscillator, or the main clock. This gives a wide range of potential

timing choices of watchdog operation under different power reduction conditions. It

also provides the ability to run the WDT from an entirely internal source that is not

dependent on an external crystal and its associated components and wiring for

increased reliability.

7.17 Clocking and power control

7.17.1 Integrated oscillators

The LPC1311/13/42/43 include three independent oscillators. These are the system

oscillator, the Internal RC oscillator (IRC), and the watchdog oscillator. Each oscillator can

be used for more than one purpose as required in a particular application.

LPC1313 Datenblatt(PDF) 21 Page - NXP Semiconductors

LPC1313 Datenblatt(HTML) 21 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Datenblatt Download

Link URL