810-0005-D01 datasheet(5/16 Pages) MAGNETROL

5 / 16 page

50-607 Kotron Model 810 RF Point Level Sensor

2.2

Electrostatic Discharge (ESD)

Handling Procedure

Magnetrol’s electronic instruments are manufactured to the

highest quality standards. These instruments use electronic

components that may be damaged by static electricity pre-

sent in most work environments.

The following steps are recommended to reduce the risk of

component failure due to electrostatic discharge.

• Ship and store circuit boards in anti-static bags. If an anti-

static bag is not available, wrap the board in aluminum

foil. Do not place boards on foam packing materials.

• Use a grounding wrist strap when installing and removing

circuit boards. A grounded workstation is recommended.

• Handle circuit boards only by the edges. Do not touch

components or connector pins.

• Make sure that all electrical connections are completely

made and none are partial or floating. Ground all

equipment to a good, earth ground.

2.3

Installation

2.3.1 Installation Location

Kotron point sensors should be located in areas allowing

easy access for service, calibration and monitoring. Units

should not be exposed to ambient temperatures above

+160° F (+71° C) or below -40° F (-40° C). Special pre-

caution should be taken to prevent exposure to corrosive

atmosphere, excessive vibration, shock or physical damage.

Sensing probes should be located close to the tank wall for

greatest sensitivity in non-conductive media. Probes should

be isolated from severe motion in the tank, because surface

turbulence may cause signal deviation.

NOTE: Do not attempt to disassemble probe from housing

until

the

wires

have

been

disconnected

and

the

electronic module has been removed. Consult Section 3.1,

Troubleshooting on page 8.

810-0005-D01 Datenblatt(PDF) 5 Page - Magnetrol International, Inc.

810-0005-D01 Datenblatt(HTML) 5 Page - Magnetrol International, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Datenblatt Download

Link URL