810-0005-D01 datasheet(6/16 Pages) MAGNETROL

6 / 16 page

50-607 Kotron Model 810 RF Point Level Sensor

2.3.2 Probe Length

If the geometry of your application requires a probe short-

er than 12" (305 mm) of active length, refer to Figure 1

below to determine the minimum dielectric constant in

which it can be used.

2.4

Mounting

When installing, apply wrench to mounting gland only.

Guard element should be located free of nozzle.

Caution: When a probe is used in an abrasive medium, inspect the

probe at least annually for visible surface wear. In case any

wear is found, replace the probe or consult the factory.

2.4.1 Horizontal Mounting

Unit will signal at probe level. Refer to Figures 2 and 3.

Caution: Do NOT horizontally mount the unit in a nozzle deeper than

3" (75 mm). Refer to Figures 2 and 3. The medium may

build up in the nozzle and cause false actuation.

2.4.2 Vertical Mounting

As medium rises on the probe, the unit will signal at a

point determined by the calibration of the unit and the

dielectric constant of the medium. In conductive media,

the actuation point will be at the tip of the probe over a

wide range of adjustment. Refer to Figure 4.

INSTALLATION INSTRUCTIONS

1. Thread amplifier assembly into mounting bushing on tank

using suitable pipe compound or thread tape. Assembly

may also be attached to a flange and bolted to the vessel

using a suitable gasket.

2. Tighten securely, being certain that the wrench is applied

ONLY to the mounting gland. Refer to Figures 2

through 4.

Probe Length vs. Dielectric Constant

Figure 1

Minimum dielectric constant of material

Mounting Gland

Nozzle

Mounting Gland

Figure 2

Horizontal Mounting

Figure 3

Horizontal Mounting in Nozzle

Mounting Gland

Figure 4

Mounting

Gland

Mounting

Gland

Nozzle

Mounting

Gland

810-0005-D01 Datenblatt(PDF) 6 Page - Magnetrol International, Inc.

810-0005-D01 Datenblatt(HTML) 6 Page - Magnetrol International, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Datenblatt Download

Link URL