USB2532 datasheet(31/60 Pages) SMSC

31 / 60 page

USB 2.0 Hi-Speed 2-Port Hub Controller

Datasheet

SMSC USB2532

Revision 1.0 (06-17-13)

DATASHEET

In this operation, following the 7-bit slave address, the 8-bit register address is written indicating the

start address for the subsequent sequential read operation. In the read sequence, every data access

is a data read from a data register where the register address increments after each access. The write

sequence can end with optional Stop (P). If so, the read sequence must begin with a Start (S).

Otherwise, the read sequence must start with a Repeated Start (Sr).

Figure 7.2 shows the format of the read operation. Where color is visible in the figure, blue and gold

indicate signaling from the I2C master, and gray indicates signaling from the slave.

7.1.2

Pull-Up Resistors for I2C

The circuit board designer is required to place external pull-up resistors (10 k

Ω recommended) on the

SDA & SCL signals (per SMBus 1.0 Specification) to Vcc in order to assure proper operation.

7.2

SMBus Slave Interface

The USB2532 includes an integrated SMBus slave interface, which can be used to access internal

device run time registers or program the internal OTP memory. SMBus detection is accomplished by

detection of pull-up resistors (10 K

Ω recommended) on both the SMBDATA and SMBCLK signals. To

disable the SMBus, a pull-down resistor of 10 K

Ω must be applied to SMBDATA. The SMBus interface

can be used to configure the device as detailed in Section 6.1, "Configuration Method Selection," on

page 25.

Note: All device configuration must be performed via the SMSC Pro-Touch Programming Tool. For

additional information on the Pro-Touch programming tool, contact your local SMSC sales

representative.

7.2.1

SMBus Run Time Accessible Registers

Table 7.1 provides a summary of the SMBus accessible run time registers. Each register is detailed in

the subsequent tables.

Figure 7.2 I2C Sequential Access Read Format

7-Bit Slave Address

n n n n n n n n

ACK

for xxxxxxxx

n n n n n n n n

ACK

for xxxxxxxx + 1

...

n n n n n n n n

NACK

If previous write setting up

Stop (P), otherwise it will be

Repeated Start (Sr)

for xxxxxxxx + y

7-Bit Slave Address

xxxxxxxx

Address

(bits 7-0)

Optional. If present, Next

access must have Start(S),

otherwise Repeat Start (Sr)

USB2532 Datenblatt(PDF) 31 Page - SMSC Corporation

USB2532 Datenblatt(HTML) 31 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Datenblatt Download

Link URL