AD9912ASLASHPCBZ datasheet(34/40 Pages) AD

34 / 40 page

AD9912

Rev. F | Page 34 of 40

To reset the entire chip, the user can use the (non-autoclearing) soft reset bit in Register 0x0000.

Table 17.

Bits

Bit Name

Description

DDS reset

Reset of the direct digital synthesis block. Reset of this block is very seldom needed.

Table 18.

Bits

Bit Name

Description

PD fund DDS

Setting this bit powers down the DDS fundamental output but not the spurs. It is used during tuning

of the SpurKiller circuit.

S-div/2 reset

Asynchronous reset for S prescaler.

S-divider reset

Synchronous (to S-divider prescaler output) reset for integer divider.

SYSTEM CLOCK (REGISTER 0x0020 TO REGISTER 0x0022)

Table 19.

Bits

Bit Name

Description

[4:0]

N-divider

These bits set the feedback divider for system clock PLL. There is a fixed divide-by-2 preceding this

block, as well as an offset of 2 added to this value. Therefore, setting this register to 00000 translates to

an overall feedback divider ratio of 4. See Figure 45.

Table 20.

Bits

Bit Name

Description

VCO auto range

Automatic VCO range selection. Enabling this bit allows Bit 2 of this register to be set automatically.

[6:4]

Reserved

Reserved.

2× reference

Enables a frequency doubler prior to the SYSCLK PLL and can be useful in reducing jitter induced by

the SYSCLK PLL. See Figure 44.

VCO range

Selects low range or high range VCO.

0 = low range (700 MHz to 810 MHz).

1 = high range (900 MHz to 1000 MHz). For system clock settings between 810 MHz and 900 MHz, use

the VCO auto range (Bit 7) to set the correct VCO range automatically.

[1:0]

Charge pump current

Charge pump current.

00 = 250 μA.

01 = 375 μA.

10 = off.

11= 125 μA.

AD9912A/PCBZ Datenblatt(PDF) 34 Page - Analog Devices

AD9912A/PCBZ Datenblatt(HTML) 34 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Datenblatt Download

Link URL